Pharmacokinetics and oral bioavailability of cannabidiol in horses after intravenous and oral administration with oil and micellar formulations.

BACKGROUND: Intravenous pharmacokinetics and oral bioavailability of cannabidiol (CBD) with different formulations have not been investigated in horses and may represent a starting point for clinical studies. OBJECTIVES: To describe pharmacokinetics after intravenous and oral administrations with oil and micellar formulations and simulate different treatments. STUDY DESIGN: Single intravenous experiment and two-way randomised oral experiments, Latin-square design. METHODS: Eight healthy horses received intravenous CBD at 1.00 mg/kg dose, oral CBD in sesame oil and in micellar formulation, both at 10.00 mg/kg. Concentrations were measured using LC-MS/MS and fitted by nonlinear mixed effect modelling. Parameters obtained were used to simulate single and multiple treatments at steady state. RESULTS: Intravenous and oral concentrations were simultaneously fitted using a three-compartment model. Final estimates indicate that CBD has a volume of distribution of 36 L/kg associated with a systemic clearance of 1.46 L/h/kg and half-lives ranged between 24 and 34 h. Oral bioavailability was close to 14% for both oral administrations. Simulated dose regimen of CBD every 12 and 24 h predicted similar percentages to reach effective plasma concentration with both oral formulation at 10.00 mg/kg. MAIN LIMITATIONS: A small horse population was used (8 horses per trial). CONCLUSIONS AND CLINICAL IMPORTANCE: Oral bioavailability was low at the doses studied but fell within the range described for horse and other species. CBD had a high steady-state volume of distribution, a high clearance and long half-lives. No adverse reactions were detected at any dose or route. The micellar formulation showed a faster absorption and higher concentration peak, while the oil formulation presented lower levels, but more maintained over time. Simulations predicted that both could be useful in multiple oral dose treatments. These results indicated that CBD could be of interest, but further studies are needed to evaluate its clinical use in horses.

Effect of temperature in the degradation of cannabinoids: From a brief residence in the gas chromatography inlet port to a longer period in thermal treatments.

The substantial increase in legalization and subsequent regulation of cannabis has intensified the control and analytical monitoring of cannabis products to assure sample quality and control the cannabinoid content of the crop. In this sense, the restriction on cultivating legal cannabis plants has been limited to 0.2-0.3% of Δ9-THC content, depending on the host country's laws. Thereby, cannabis flowers containing more than this limit are considered illicit drug-type cultivations and require the obtention of specific permits to work with them. The official method established by the European Commission set the gas chromatography/flame ionization detector (GC-FID) as the proper instrument to analyze the delta-9 tetrahydrocannabinol (Δ9-THC) content. In the present work, the potential drawbacks associated with the utilization of the official method for the evaluation of the Δ9-THC content have been described. Thus, the effect of the GC injector port temperature in the degradation of cannabinoids was evaluated, observing the degradation of CBD by 20%, generating Δ9-THC and CBN as by-products. Likewise, 17.2% of Δ9-THC was degraded, producing CBN as a by-product. Therefore, despite the brief residence of cannabinoids in the GC inlet, the effect of temperature is noteworthy and must be considered. Derivatization of cannabinoids should be a mandatory step to prevent the thermal degradation of cannabinoids, assuring the accuracy of the results. Furthermore, the evaluation of cannabinoid degradation thermally treated for longer periods of time was carried out. The kinetic degradation of CBD was evaluated in this way, observing a degradation of 0.22 µg/L per second. At the same time, the kinetics of the appearance of Δ9-THC demonstrates the intermediate nature of this cannabinoid, being degraded at 0.03 s-1 µM-1. The degradation of CBD also produced CBN and CBE as by-products.

Polydopamine coated hypodermic needles as a microextraction device for the determination of tricyclic antidepressants in oral fluid by direct infusion MS/MS.

In-needle microextraction consists of the confinement of the sorbent, by coating or packing, inside a metallic needle. The size of the needles reduces the eluent requirements providing an efficient preconcentration of the analytes. In this work, hypodermic needles coated with polydopamine (PDA) are presented as microextraction devices to isolate six tricyclic antidepressants from oral fluid samples. The coating consists of the in-surface polymerization of dopamine at pH 8.5 and mild conditions (room temperature and water as solvent). The PDA coating over the stainless-steel surface confers the needles with a high extraction ability towards the target analytes. After the extraction, the eluates were analyzed by direct infusion MS spectrometry, working in multiple reaction monitoring (MRM) mode, which provided a sample throughput of 30 samples per hour. The variables affecting the synthesis (number of coating cycles, the concentration of dopamine, and needle surface pre-treatment) and the extraction (sample salinity, sample loading cycles, and the number of elution strokes) were studied in depth. Under the optimum conditions, a matrix-matched calibration model was built. The limits of quantification are between 2 and 5 ng mL-1 with linear ranges up to 1000 ng mL-1 for all analytes. The precision, expressed as relative standard deviation (RSD), is better than 10% for all analytes. Accuracy was calculated as recovery, and the obtained values are between 84% and 107%. A single-blind assay was also performed to evaluate the suitability of the method for real application.

Polymeric ionic liquid immobilized onto paper as sorptive phase in microextraction.

A new planar sorptive phase based on the simple immobilization of polymeric ionic liquids on paper is proposed. The sorptive phase can develop hydrophobic or mixed-mode (combining hydrophobic and ion exchange) interactions with the target analytes. The polymer is prepared by the Radziszewski reaction, which takes place in aqueous media, and it has been thoroughly characterized by different techniques including infrared spectroscopy, matrix-assisted laser desorption/ionization coupled to high-resolution mass spectrometry and proton nuclear magnetic resonance. Three different strategies aimed to immobilize the polymeric ionic liquid on paper have been evaluated. Among them, simple thermal curing at 120 °C was selected. The as-prepared paper has been evaluated for the extraction of several non-steroidal anti-inflammatory drugs from urine, the analytes being finally determined by liquid chromatography with tandem mass spectrometry. The method detection limits were 3.8, 7.2, 6.8, 9.4, 15.7, and 5.1 µg/L for indomethacin, diclofenac, tolmetin, ketoprofen, naproxen, and ibuprofen, respectively. Calibration models were linear (R2 > 0.9949) up to 1000 µg/L. The intra-day precision, expressed as relative standard deviation and calculated at three different concentrations levels (limit of quantification, 250 µg/L, and 1000 µg/L), varied between 1.1 and 13%. The accuracy, calculated as relative recovery, was in the range from 72 to 95%, thus being considered appropriate. The easiness of polymeric ionic liquid paper synthesis and the multi-sample extraction protocol designed allows the processing of a high number of samples at the same time.

Melamine Sponge Functionalized with Urea-Formaldehyde Co-Oligomers as a Sorbent for the Solid-Phase Extraction of Hydrophobic Analytes.

A new procedure for the functionalization of melamine sponge (MeS) with urea-formaldehyde (UF) co-oligomers is put forward. The procedure differs from the typical synthesis of the UF co-polymer, as it employs a base-catalyzed condensation step at certain concentrations of urea and formaldehyde. The produced melamine-urea-formaldehyde (MUF) sponge cubes are hydrophobic, despite the presence of hydrophilic groups in the oligomers. The MUF sponge developed herein is used as a sorbent for the solid-phase extraction of 10 analytes, from 6 different classes (i.e., non-steroidal anti-inflammatory drugs, benzophenones, parabens, phenols, pesticides and musks) and an analytical method is developed for their liquid chromatographic separation and detection. Low limits of quantification (0.03 and 1.0 µg L-1), wide linear ranges and excellent recoveries (92⁻100%) are some of the benefits of the proposed procedure. The study of the synthesis conditions of MUF cubes reveals that by altering them the hydrophilic/lipophilic balance of the MUF cubes can be tuned, hinting towards a strong potential for many other applications.

Carbon Nanohorn Suprastructures on a Paper Support as a Sorptive Phase.

This article describes a method for the modification of paper with single-wall carbon nanohorns (SWCNHs) to form stable suprastructures. The SWCNHs form stable dahlia-like aggregates in solution that are then self-assembled into superior structures if the solvent is evaporated. Dipping paper sections into a dispersion of SWCNHs leads to the formation of a thin film that can be used for microextraction purposes. The coated paper can be easily handled with a simple pipette tip, paving the way for disposable extraction units. As a proof of concept, the extraction of antidepressants from urine and their determination by direct infusion mass spectrometry is studied. Limits of detection (LODs) were 10 ng/L for desipramine, amitriptyline, and mianserin, while the precision, expressed as a relative standard deviation, was 7.2%, 7.3%, and 9.8%, respectively.

Lab-on-a-Valve Mesofluidic Platform for On-Chip Handling of Carbon-Coated Titanium Dioxide Nanotubes in a Disposable Microsolid Phase-Extraction Mode.

Mesofluidic lab-on-a-valve (LOV) platforms have been proven suitable to accommodate automatic micro-solid-phase extraction (µSPE) approaches with on-chip handling of micrometer-bead materials in a fully disposable mode to prevent sample cross-contamination and pressure-drop effects. The efficiency of the extraction process notably depends upon the sorptive capacity of the material because the sorbent mass is usually down to 10 mg in LOV devices. Nanomaterials, capitalizing upon their enhanced surface-to-volume ratio and diversity of potential chemical moieties, are appealing alternatives to microbead sorbents. However, the handling and confinement of nanomaterials in fluidic chip structures have been challenging to date. This is most likely a consequence of the aggregation tendency of a number of nanomaterials, including carbon-based sorbents, that leads to excessive back-pressure in flowing systems along with irreproducible bead loading. This paper addresses these challenges by ad hoc synthesis of hybrid nanomaterials, such as porous carbon-coated titanium dioxide nanotubes (TiO2-NT@pC). Tailoring of the surface polarity of the carbon coating is proven to foster the dispersion of TiO2-NT@pC in LOV settings while affording superior extraction capability of moderately nonpolar species from aqueous matrices. The determination of trace-level concentrations of butylparaben (BPB) and triclosan (TCS) in seawater samples is herein selected as a proof-of-concept of the exploitation of disposable nanomaterials in LOV. The mesofluidic platform accommodating µSPE features online hyphenation to liquid chromatography/tandem mass spectrometry (LC/MS/MS) for reliable determination of the target analytes with excellent limits of detection (0.5 and 0.6 ng/L for BPB and TCS, respectively) and intermediate precision (relative standard deviation <5.8%). For 5.0 mL of sample and 200 µL of eluent, enrichment factors of 23 and 14 with absolute extraction efficiencies of 90% ± 14% and 58 ± 8% for BPB and TCS, respectively, were obtained. The relative recovery values of 107% (BPB) and 97% (TCS) in seawater demonstrate the applicability of online LOV-LC/MS/MS using TiO2-NT@pC for handling troublesome environmental samples.

Determination of urinary 5-hydroxyindoleacetic acid by combining Dµ-SPE using carbon coated TiO2 nanotubes and LC-MS/MS.

BACKGROUND: In this article, carbon coated titanium dioxide nanotubes (TiO2-NT@C) are employed for the determination of 5-hydroxyindole-3-acetic acid in urine by LC-MS/MS. RESULTS: All the variables involved in the extraction have been studied and optimized in depth. The method has been analytically characterized on the basis of its linearity, accuracy, sensitivity and precision. The LOD is 155.8 µg/l while the repeatability and the reproducibility, expressed as RSD, are better than 5.42 and 5.25%, respectively. The obtained relative recovery is 115%. CONCLUSION: TiO2-NT@C permit the efficient extraction of 5-hydroxyindole-3-acetic acid from complex biological samples such as urine allowing its sensitive determination by LC-MS/MS.